例句與造句

1. The studies of in - layer heterogeneity are as follows : the text depicts the characteristics of heterogeneity by calculating the coefficient of variability , kmax / k and k . max / k . min of sand layers of different sedimentous microfacies ; divides interlayer into two types , and counts their numbers , thickness , frequency and density of a single sand layer according to the characteristics of lithology and logging , finally summarizes the characteristics of interlayer distributing ; sets up five in - layer heterogeneity models and points out that the primary models are model a and c . the studies of between - layer heterogeneity are as follows : the text depicts sand layers " growth and distributing conditions by calculating the lamination factor , sandstone density and overlap coefficient ; makes certain the lithology and thickness of interlayer by the method of contrasting the typical curves
   層內非均質性研究，通過計算不同沉積微相砂體滲透率的變異系數、突進系數以及級差來說明主要儲集微相的非均質特征；據巖性及電性特征，將層內夾層分為兩類，統計單砂層段內夾層的個數、累積夾層厚度、夾層頻率及夾層密度，并且根據夾層頻率及密度平面分布圖統計出每層的頻率相對高值區和低值區，總結夾層分布特征；根據物性參數隨深度的變化趨勢建立了五種儲層層內物性非均質模式，指出研究區內以a型和c型模式為主。
2. On the basis of utilizing geometric conversion and modification principle of spur and helical gears , the mathematical model for geometric parameters and modification of overlapping coefficients of gear was established , and the calculation method of sliding frictional coefficients under elasto - hydrodynamic lubrication state was introduced , thus let the calculation method of meshing efficiency of gears be more coinciding with the practical application
   在運用直、斜齒輪幾何換算和變位原理的基礎上，建立齒輪的幾何參數和重迭系數修正的數學模型，介紹了彈流潤清狀態滑動摩擦因數的計算方法，從而使齒輪嚙合效率計算方法與實際應用更吻合。
3. 3 . the trapping characteristics of ordinary helical gear pump are lucubrated by theory for the first time , the theoretic relation of the gear rotor between the end overlap coefficient and trapping phenomenon is discussed respectively with clearence or without clearcence , and the relation of trapping volume with the rotational angle turn is also discussed . the selective range of the helical angle that can eliminate completely the trapping of helical gear pump is gained , which never appeared in literature before
   首次對普通斜齒齒輪泵的困油特性進行深入的理論研究，分別討論了有側隙和無側隙時普通斜齒齒輪泵轉子的端面重合度與困油現象之間的理論關系，以及困油容積隨轉角的變化關系，得到了完全消除斜齒齒輪泵困油沖擊的螺旋角機械科學研究院博士學位論文的選擇范圍。
4. Based on the analysis and discussion of characteristics and law of gear engagement under condition of elasto - hydrodynamic , a calculation method on sliding and rolling work loss of standard spur gear transmission had been put forward , and the relationship of geometric parameters and overlapping coefficients of gear with sliding work loss was revealed
   摘要基于彈流潤滑狀態下的齒輪嚙合特性及規律分析和討論，提出了標準直齒傳動的滑動功損及滾動功損的計算方法，揭示了齒輪的幾何參數和重迭系數與滑動功損的關系。
5. It's difficult to find overlapping coefficient in a sentence. 用overlapping coefficient造句挺難的